1x Drive side cap replacement for the Precision Pro Powermeter, including screws and O-ring.

Note:

Do not directly spray your power meter with a pressure washer. Cover your power meter to avoid direct contact with any cleaner/degreaser. Some degreasers can cause your battery housing to become brittle. If you get cleaner/degreaser on your power meter, make sure to rinse it off immediately.

Take the battery cover off WHEN DRY and wipe down the gasket area with a dry paper towel to ensure that no cleaner/degreaser has gotten in between the gasket and fasteners.

Ensure that the drive side (right) battery cap is installed securely in the locked position and that the screws are fastened snug.
The O-Ring should not be visible after install and the cap should be flush with the pod housing. It is important to regularly check the integrity of your o-ring. 4iii recommend occasionally lubricating your o-ring by applying a light coating of silicone based grease to protect it from drying out and cracking.

Manufacturer part number: MK102